The floor structure is only as strong as its weakest link. If the furnace installers cut a floor joist to install some duct work it is likely the cause of the bounce. By cutting out more then 1/3 of the floor joist you can weaken it to the point that it cracks and...
In older homes the heat source in the kitchen was often placed on an inside wall because it was easier. Today we place the heat source primarily on the outside wall under or near the windows or doors. By not providing heat near the sink in some older homes you often...
There is a science to the duct work in a furnace distribution system. For instance, if you vent a duct off the end of a plenum you will get more heat than taking the same vent off the side of the same plenum line. This is usually not something you have control over so...
Adding warm moist air into a cold attic is not a good idea as the change in temperature causes the air to condense when it reaches its dew point. This condensation can accumulate on surfaces and cause rot or enough moisture to form running water that will run onto the...
Frost development in an attic is the result of heat that is moving up through the insulation into the cold attic. More often than not you may find that the heat is coming from a vent that is pumping warm moist air into the attic. On extremely cold days or days of vast...
Recent Comments